• Mazda MIATA MX-5
• Fits on chassis codes NA & NB 1990-2005
  

Benefits:

The Windblokker® has a frame manufactured from aircraft aluminum, with a nylon mesh center, the Windblokker® can be used with or without roll bars and will not interfere with plastic or glass rear windows. This Windblokker® will fit the late Mk1's with the factory brace bar behind the seats.  The flat black finish of the Windblokker® will complement any interior and looks like it was factory installed. The Windblokker® is easy and fast to install because it fits to the sides of the seatbelt towers and pivots on these mountings. This Windblokker® can be folded down and then will pivot flat against the rear shelf when not in use.

• Considerably less wind noise inside the cockpit
• Easier to make any calls from your cell phone
• Your partner or companion will love it
• Now you can keep the top down all the time and enjoy your Mazda
• Fully tested at high speeds
• The Windblokker® can stay in place even when the convertible top is closed thus no removal necessary.
  

Recommended Maintenance:

It is best to clean your Windblokker® frame with ArmorAll®. The nylon mesh center may be brushed gently with a soft clothing brush every so often

Installation:

• Locate in the rear side panels behind the seats 1 push pin and 1 bolt with a sphere mounted on the top of the bolt.
• Remove the sphere bolt with a 10mm socket.
• Take the Windblokker and set it in place, the washer goes on the supplied bolt before inserting it through the Windblokker mounting bracket. then slide the spacer on the bolt.
• You can now insert the supplied bolt into the threaded body of your MX-5, tighten the bolt snugly.
• This Windblokker® will fit the late Mk1's with the factory brace bar behind the seats.